Assume that in the face-milling operation the work piece dimensions are 100 mm by 250 mm. The cutter 1 answer below »

Assume that
in the face-milling operation the work piece dimensions are 100 mm by 250 mm.
The cutter is 150 mm in diameter, has eight teeth, and rotates at 300 rpm. The
depth of cut is 3 mm and the feed is 0.125 mm/tooth. Assume that the specific
energy requirement for this material is 5W – s/mm3 and that only 75% of the
cutter diameter is engaged during cutting. Calculate (a) the power required and
(b) the material-removal rate.

Don't use plagiarized sources. Get Your Custom Essay on
Assume that in the face-milling operation the work piece dimensions are 100 mm by 250 mm. The cutter 1 answer below »
Just from $13/Page
Order Essay